1. Trim previous layup - sand foam flush
2. Pressure test tank with full water - looks OK
   

1. Pressure test tank - air only - looks OK - loses 1/2" water pressure in 24 hrs.
   

1. Prepare all surfaces for repair layups - strake top
2. Test kerosene heater for garage - works fine after 14 year layoff
   

1. Micro and glass top of strake
2. Level, fit and bolt left wing to spar
3. Fit plywood rib for wing location reference - remove wing

1. Begin fitting and trimming strake bottom - left

1. Continue fitting and trimming strake bottom - left

1. Continue fitting and trimming strake bottom - left and ribs
2. Cut holes in fuselage side

11/15/98

1. Continue fitting and trimming strake bottom - left

1. Continue fitting and trimming strake bottom - left
2. Cut glass for all strake bottom attach layups
3. Glass 1 BID strake tail inner surface and outboard edge
4. Glass 2 BID around 1 1/4" fule hole
5. Micro all baffle holes and notch edges

1. Trim previous layup
2. Flox lower strake to fuselage/spar
3. Glass 2 BID strake/spar joint and peel ply
4. Glass 2 BID strake/fuselage joint and peel ply
5. Glass 1 BID rear strake tail/spar bottom and peel ply

1. Fit all ribs to bottom strake
2. Sand and trim previous layups - sand for strake/fuselage inside layups
3. Begin fitting top strake

1. Prepare all strake bottom and ribs for epoxy layer
2. Prepare strake/fuselage inside layups
3. Epoxy and peel ply both (1) and (2)